SELECT SYSTEM MODE
SELECT SYSTEM MODE
SELECT SYSTEM MODE
Setpoint is displayed on the right side of the screen.
Press ▲/
▼
to scroll through options for system
preferences. The selected option flashes.
i
Note: System modes available
depend upon which system type is
selected in Service Menus.
PRESS ANY KEY TO BEGIN
1.
Press
System
preferences.
Note: Selected option fl ashes.
2.
Press ▲/
▼
to select Heat, Cool,
Auto, Off, or
3.
Press
to save changes.
Done
In "Heat" and "Cool" modes, only one
setpoint is displayed for each, and only the
selected mode (e.g.,Heat) is applied. "Auto"
mode switches automatically between Heat
and Cool. Auto mode controls the room's
temperature to the programmed Heat
and Cool Setpoints. "Off" mode disables
all thermostat outputs; and only the zone
temperature and clock are displayed. If
Emergency (Em) heat is enabled in a Heat
Pump system, Emergency acts as the primary
heat source.
to select system
Em
(Emergency).
14