Peco T8000 Operating Manual page 18

PROGRAM SCHEDULED EVENTS PROGRAM SCHEDULED EVENTS PROGRAM SCHEDULED EVENTS
Press ▲/ ▼to select a desired Heat Setpoint for the
currently selected scheduled event (Occupied1).
i
Note: To return to the menu of scheduled
events and continue programming, select
after Step 11.
Next
i
Note: To program 5-1-1 day or 5-2 days,
see Service Menu 100 ("Performance PRO
T8000 Series Installation Guide"). Block-
programmed days flash as a group.
PRESS ANY KEY TO BEGIN
8. Press ▲/ ▼ to select a scheduled event
(e.g, Occupied1, etc.), then Next.
9. Press ▲/ ▼to schedule start time for
event (in 15-minute periods), then Next.
Now select a Heat Setpoint and/ or Cool
Setpoint for the scheduled event (available
options depend upon system type selected).
10. Press ▲/ ▼to select desired Heat
Setpoint, then press Next.
11. Press ▲/ ▼to select desired Cool
Setpoint, then press Next. Note: The
next event (e.g., Unocc1) begins fl ashing
after is selected. Complete steps
Next
3-11 for each scheduled event.
12. Press to exit schedule mode.
Done
Note: Pressing
will show
Select Day
after step 11
Go Back
on display.
18