Select System Mode - Peco T4500 Operating Manual

SELECT SYSTEM MODE

SELECT SYSTEM MODE SELECT SYSTEM MODE
Setpoint is displayed in the upper-right area.
Press ▲/ ▼ to scroll through options for system
preferences. The selected option fl ashes.
i
Note: System modes available are
dependent upon which system type
is selected in Service Menus.
PRESS ANY KEY TO BEGIN
1. Press
System
preferences.
Note: Selected option fl ashes.
2. Press ▲/ ▼ and select Heat, Cool,
Auto, Off, or
3. Press to save changes.
Done
In "Heat" and "Cool" modes, only one setpoint
is displayed for each, and only the selected
mode (e.g.,Heat) is applied. "Auto" mode
switches automatically between Heat and
Cool. Auto controls the room's temperature
to the programmed Heat and Cool
Setpoints."Off" mode disables all thermostat
outputs; and only the zone temperature
and clock are displayed. If Emergency (Em)
heat is enabled in a Heat Pump system,
Emergency acts as the primary heat source.
to select system
Em (Emergency).
14