AT&T MERLIN Plus System Manual page 82

PROGRAMMING
HOW TO USE
5-18 Section 5: Reference
Dial the intercom number or touch the Auto Intercom button for the
2
voice terminal you are administering.
A green light goes on next to the Auto Intercom button. Green lights go on next to the buttons
of any lines already assigned to the voice terminal.
Touch the line button until the green light next to it shows the line
3
assignment you want:
Green light on = the line is assigned to the voice terminal
Green light off = the line is not assigned to the voice terminal
To make the line Button-Free, dial one of these two codes:
4
– Dial *31 if you want the voice terminal to ring.
– Dial *32 if you do not want the voice terminal to ring.
Touch Administer.
5
The console beeps twice.
Leave administration mode by sliding the T/P switch to the center
6
position.
To reassign lines to separate buttons on a voice terminal that has Button-Free
Line Operation:
Enter administration mode by sliding the T/P switch to P and touching
1
Administer.
Touch the Auto Intercom button for the voice terminal you are
2
administering.
Dial *34.
3
A green light should go on next to the lines that have been assigned to the voice terminal.
Touch Administer.
4
The console beeps twice.
Leave administration mode by sliding the T/P switch to the center
5
position.
None
If you do not have a line button for a call that you have received or that has
been transferred to you, you can still put the call on hold using the Hold
button. To retrieve the call, you can use the Hold Retrieve feature. (See
"Hold Retrieve.")