Lucent Technologies MERLIN LEGEND Release 6.0 Maintenance And Troubleshooting Manual page 39

MERLIN LEGEND Communications System Release 6.0
Maintenance and Troubleshooting 555-660-140
Introduction
Preparation for Hardware Maintenance
For a MERLIN LEGEND Communications System Release 2.0 or earlier:
1. Pry the clips from the housing on both sides of the control unit;
use a screwdriver if they are difficult to remove.
2. Carefully pull the housing towards you.
NOTE:
If the MERLIN LEGEND (Release 2.0 or earlier) system has more
than one carrier, make sure you hold the housing assembly on the
basic carrier at the sides; otherwise, the housing may disassemble
as the front and side panels are only slotted together.
Figure 1–5. Removing the Control Unit Housing
MERLIN II and
MERLIN LEGEND 2.1 and later
Communications System
1
MERLIN LEGEND 2.0
and earlier
Communications System
Housing
1
Clip
gure
2
2
Housing
Issue 1
February 1998
Page 1-19