Fluke 190 Series II User Manual page 156

Fluke 190 Series II
Users Manual
The instrument firmware can be loaded using a dedicated
Fluke software program (only available for Fluke
(authorized) workshops).
Calibration constants stored in D5000, D5002 can be
read using special remote interface commands (only
available for use by Product Development). The
calibration constants are generated when the meter is
sent through its calibration process and are fundamental
to the test tool operation.
To clear the saved screens and instrument setups:
1 Push the SAVE button.
SAVE
Press F4 – FILE OPTIONS...
2
F4
If you see a screen like figure C-1, no screens and
instrument setups are stored. Press the F4 key (CLOSE)
to exit.
If you see a screen like figure C-2, continue at step 3
below.
C-2
Figure C-1. Screen if memory is empty
Figure C-2. Screen if memory is not empty