Xerox 8550YDP - Phaser Color Solid Ink Printer User Manual page 88

Control Panel Cover
Use your fingers or a small screwdriver
to pry up on the left side of the cover as
shown to the right, and then pull it
forward. After the cover is loose, press
down on the Control Panel to release it
from the cover.
Keep the Control Panel attached so the printer will function after removing the
Control Panel cover.
Left & Right Side Covers
Each side cover has latches along the
top edge in the locations shown to the
right. Release them by pulling up on the
rounded area near the back of the
printer and near the front cover.
The right side cover has one more latch
located next to the power cord
receptacle. You may need to release this
latch when removing the cover.
Exit Cover
Mounting pins located on each side of
the exit cover are captured by the left
and right side covers. Be sure to install
the exit cover and position the pins into
notches on the Ink Loader Assembly
frame before installing the side covers.
Also, make sure posts on each side of
the exit door slide freely within the
groove on the bottom of the exit cover.
page 80
Pry Here To
Remove Cover
Mounting Pin
PHASER 8550, 8500, & 8400 SERVICE SECTION
Right Side Cover Only
Post On
Exit Door
Version 1.0