Small Computer System Interface (Scsi) Messages (Some Models) - IBM IntelliStation E Pro Type 6216 User Manual

POST message
00180800 An unsupported PCI device is installed.
Action: Remove the PCI adapters. If you can start the computer without the adapters, reinstall each
If the problem remains, call for service.
00181000 PCI error.
Action: Remove the PCI adapters. If you can start the computer without the adapters, reinstall each
If the problem remains, call for service.
01295085 The ECC checking hardware test failed.
Action: Call for service.
01298001 No update data is available for the processor.
Action: Update the system BIOS to a level that supports the microprocessors installed in the
01298101 The update data for the microprocessor is incorrect.
Action: Update the system BIOS to a level that supports the microprocessors installed in the
01298200 Microprocessor speed mismatch
Action: The microprocessors installed do not run at the same speed; install microprocessors with
I9990301 A hard disk drive error occurred.
Action: Call for service.
I9990305 POST could not find an operating system.
Action: Install an operating system. If you have already installed the operating system, check the
If you cannot reinstall the operating system, call for service.
I9990650 AC power has been restored.
Action: No action is required. This message appears each time AC power is restored to the
Other Numbers POST found an error.
Action: Follow the instructions on the screen.
Table 3. POST error messages (continued)

Small computer system interface (SCSI) messages (some models)

If your computer has an Ultra160 SCSI adapter installed and you receive a SCSI error
message, one or more of the following might be causing the problem:
•
•
•
•
•
adapter one at a time and retest after each is reinstalled. When an adapter fails, replace it.
adapter one at a time and retest after each is reinstalled. When an adapter fails, replace it.
computer.
computer.
identical speeds.
drive startup sequence. If the drive sequence is correct, run the diagnostic tests to verify that
the hard disk drive is functioning correctly. If there is a problem with the hard disk drive (such
as a bad sector), you might need to reinstall the operating system.
computer after an AC power loss.
A failing SCSI device (adapter or drive)
An improper SCSI configuration
Duplicate SCSI IDs in the same SCSI chain
An improperly installed SCSI terminator
A defective SCSI terminator
Description
Chapter 5. Solving problems
79