Neoware c50 - Thin Client User Manual page 172

Setup Menus
End of Line Characters
Factory default: ^M (i.e. CR)
This text box is used to specify the characters that are to indicate the end of a line in a
data block.
To change the current definition, delete the definition displayed in the text box and
type in the new one, either as the control key character equivalent or the decimal value
of the ASCII character.
For example, the default ASCII character CR can be entered by typing the characters ^
and M, representing the keys Ctrl + M which, when pressed together would generate
the CR code.
Decimal values are entered as three-digit numbers immediately preceded by an
underscore character. Values with only two digits must be preceded by a zero. For
example, the decimal value of CR is 13, so this would be entered as _013.
Refer to the ASCII character table in the Character Sets appendix for code and decimal
references.
End of Block Characters
Factory default: None
This specifies the characters that are to indicate the end of a block of data.
To change the current definition, delete the definition displayed in the text box and
type in the new one, either as the control key character equivalent or the decimal value
of the ASCII character.
For example, the ASCII character CR can be entered by typing the characters ^
and M, representing the keys Ctrl + M which, when pressed together would generate
the CR code.
Decimal values are entered as three-digit numbers immediately preceded by an
underscore character. Values with only two digits must be preceded by a zero. For
example, the decimal value of CR is 13, so this would be entered as _013.
Refer to the ASCII character table in the Character Sets appendix for code and decimal
references.
6-88