Neoware c50 - Thin Client User Manual page 151

Lines are double height
Factory default: Unselected
This determines whether each line is single-height (normal) or double-height.
Lower case lockout
Factory default: Unselected
When selected, this will cause the LOCK key to be on so that only UPPERCASE
characters can be generated.
SOH clears screen
Factory default: Unselected
When selected, this will cause the Unisys T27 emulation to automatically clear the
screen whenever it receives an SOH character.
SOH exits forms
Factory default: Selected
When selected, this will cause the Unisys T27 emulation to automatically exit forms
mode whenever it receives an SOH character.
SO/SI XTN
SO/SI XLT
Factory default: Unselected
The setting of these options determine the effect of the ESC SO and ESC SI
sequences when receiving or transmitting data.
When receiving from the host, the setting of the SO/SI XTN option determines
whether the sequences are used to switch between standard and extended character sets
(selected), or reverse highlight and underline (unselected).
When transmitting to the host, the setting of both options determine the sequences
used for switching between standard and extended character sets, and reverse highlight
and underline as follows:
XTN XLT SO
Reverse Video
Sent as
OFF OFF SO
ON OFF ESC'.
OFF ON ESC'.
ON ON ESC'.
The SO (shift out) and SI (shift in) sequences allow switching between two sets of
characters: the standard character set and the extended character set. Each set consists
of 128 characters. When an ESC SO sequence is received from the host, the emulation
SI Extended
Underline
Sent as Begin
SI ESC SO
ESC'/ SO
ESC'/ ESC SO
ESC'/ SO
Setup Menus
Characters
End
ESC SI
SI
ESC SI
SI
6-67