Disable Bell; Connection Template To Use - Neoware c50 - Thin Client User Manual

Session Configuration
Start-up Command Group To Action
Registry Entry:
Command Line: -Nname
Default Setting:
You can specify more than one set of start-up commands in the registry. This enables
you to configure each instance of the emulator differently.
Each set of commands other than the default set must have the following heading in
the registry under HKLM\Software\Pericom\<product name>:
Startup,name
where name can be any unique identifying name. You can specify which set of start-
up commands the emulator is to use by including the following on the command line
for loading the emulator, where name is substituted with the actual name of the start-up
group required:
-Nname
If this command is not present then the emulator will use the start-up commands under
the Startup,Default heading.

Connection Template To Use

Registry Entry:
Command Line: -SE"description"
Default Setting: Untitled
This command enables you to override the default connection template used when the
emulator is loaded, as specified in the Open Session dialog box. The description must
exactly match the description assigned to a connection template already saved using
the Save Session As dialog box and must be enclosed by double-quotes.

Disable Bell

Registry Entry:
Command Line: -BE
Default Setting: Enabled
These commands enable you to turn off the terminal bell.
None
Default
None
Bell = "off"
Initialization Commands
20-7