Dec Vt Emulations; Session Configuration; Wbt Mode - Neoware c50 - Thin Client User Manual

This chapter describes features of the DEC VT terminal emulations.

Session Configuration

WBT Mode

This section describes the basic procedure for creating a session configuration when
the terminal is in WBT mode. The options available are described in detail in chapter
2.
1. Click the Configure tab in the Terminal Connection Manager then click the
Add button to display the New Connection dialog box.
2. Select Terminal Emulation Client and click OK. The Terminal Emulation
Client Connection Wizard - Connection Information dialog box will be
displayed.
3. Enter a name which will identify this session configuration for future selection in
the Connection Name box.
4. Select the DEC VT terminal emulation required in the Emulation list box.
The VT52 and VT100 emulations enable you to run applications written for the
DEC VT52 and VT100 terminals, respectively.
The VT500 7-Bit and VT500 8-Bit emulations enable you to run applications
written for the DEC VT320 terminal, the difference is in their treatment of 8-bit
control codes. When VT500 7-Bit is selected, all 8-bit codes are converted to
their 7-bit equivalents, whereas VT500 8-Bit leaves 8-bit codes unchanged. If
you are using VT200 applications, select VT500 7-Bit.
5. Specify the required VT Terminal ID setting.
6. Click Next to display the Host Information dialog box.
For a TCP/IP connection, click the TCP/IP button, enter the name or internet
address of the host computer in the Host Name box, then click Advanced for

DEC VT Emulations

DEC VT Emulations
7
7-1