Emergency Recording - Panasonic WJ-ND400K Setup Instructions

Emergency recording

Emergency recording
Sets the recording duration or recording rate when performing emergency recording by input of the emergency recording input signal. For details
about emergency recording, refer to the Installation Guide.
1
Click the [Emergency rec.] button on the setup menu.
This will display the "Emergency rec." window.
Button Functions
[Measurement]
button
Important:
• Recording may not be possible for about four seconds immediately after emergency recording is complete.
Emergency recording settings
Item
Recording duration
Model
Compression
Measurement
Max. network speed (Mbps)
Max. bit rate (ips)
Recorder setup
Recording rate
34
: Click to check for proper operation at
the specified recording rate. (page 36)
Settings
2s / 5s / 10s♦ / 20s / 30s / 1min /
3min / 5min / 10min / 30min /
Manual / Continue
Off♦ / 1ips / 2ips / 3ips / 5ips /
10ips / 15ips / All /
I-Frame
2
Configure the settings for each item.
Refer to "Emergency recording settings" table for details
about the settings.
• To configure the settings of a camera that is not shown on
the display, click the applicable camera number range
above the [Set] button to change the contents of the
display.
• Clicking a camera number range will save the currently
displayed camera settings.
3
Click the [Set] button.
Description
Specifies the duration of emergency recording.
• Selecting [Manual] records while the emergency recording
input signal is being input. Also, recording is performed for a
minimum of 8 seconds.
• Selecting [Continue] causes recording to continue until the
"Alarm [ALM]" button is clicked.
Shows the registered model numbers of the cameras.
Shows the image compression format for registered camera
images.
• Refer to "Checking and changing a camera (Manually
setting) (page 50)" for details about compression method
settings.
Shows the maximum bit rate on the network being used when
the [Measurement] button is clicked.
Shows the maximum recording rate on the network being used
when the [Measurement] button is clicked.
• A red rate setting value indicates that live images or
recording of the image may not be possible at the specified
rate.
Specifies the rate of emergency recording.
• Available settings differ according to the compression format
of the camera. Refer to "Checking and changing a camera
(Manually setting) (page 50)" for details about compression
method settings.