Panasonic WJ-ND400K Setup Instructions page 57

Item
Channel to send
Image transmission by alarm
Server directory
Duration-Pre
Duration-Post
Alteration Detection
♦Initial default
*1 You can enter the following single-byte alpha-numeric characters and symbols.
A B C D E F G H I J K L M N O P Q R S T U V W X Y Z a b c d e f g h i j k l m n o p q r s t u v w x y z
0 1 2 3 4 5 6 7 8 9 ! # $ % ` ( ) + , - . / ; = @ [ ] ^ _ ` { }
Important:
• Pre-event images are not sent when pre-event recording is not specified. For information about configuring pre-event recording settings,
refer to page 42.
Note:
• Images recorded with emergency recording can be transmitted to the FTP server.
The camera channels transmitted to the FTP server, recorded images, and the directory of the FTP server are as follows.
• Camera channels to transmit
• Recorded images
• Directory of the FTP server
Settings
Unselected♦ / All /
Cam.1 to Cam.64
Name input
(Blank♦)
Off♦ / 1 s to 10 s (Settable in 1-
second units.)
Off / 1 s to 10 s (Settable in 1-
second units.)
(5s♦)
Off♦ / On
: Camera channel of emergency recording
: Images recorded from the start of emergency recording to the time set for "Duration-Post".
: Directory set under [Image transmission by alarm] - [Server directory] for the FTP server set for
[FTP server address].
Description
Select the camera channel for image transmission by periodic
timer. Images from the camera whose check box is selected are
sent to the FTP server.
• Image transmission by periodic timer cannot be used when
the image compression format of the selected camera
channel is [MPEG-4].
Set the following items to transmit images of where an alarm
occurs at an event. Setting whether or not to transmit live
images to the FTP server where an alarm occurs at an event
can be set for scheduled time periods with "Time table
(page 46)".
Enter the send destination directory.
• Enter up to 255 single-byte alpha-numeric characters and
symbols, excluding &*:<>?\|~ and spaces.
Specify the time of the pre-event image to be sent.
• Transmission of images to the FTP server may not be
possible for "Duration-Pre" when the image compression
method of the selected camera channel is [MPEG-4].
Specify the time of the post-event image to be sent.
• Transmission of images to the FTP server may not be
possible for "Duration-Post" when the image compression
method of the selected camera channel is [MPEG-4].
Specifies whether data should be included for alteration
detection by the viewer software.
Server
*1
57