Panasonic WJ-ND400K Setup Instructions page 59

Mail settings
Item
Attach alarm image
SMTP server address
SMTP port number
POP server address
Authentication
Type
User name
Password
Destination address
Address1 to Address4
Sender's address
♦Initial default
*1 You can enter the following single-byte alpha-numeric characters and symbols.
A B C D E F G H I J K L M N O P Q R S T U V W X Y Z a b c d e f g h i j k l m n o p q r s t u v w x y z
0 1 2 3 4 5 6 7 8 9 ! # $ % ` ( ) * + , - . / : ; < = > ? @ [ \ ] ^ _ { | } ~
Settings
Off♦/On
Address input
(Blank♦)
Port number input (25♦)
Address input
(Blank♦)
None♦ / POP before SMTP /
SMTP
Name input
(Blank♦)
Enter password
(Blank♦)
Address input
(Blank♦)
Address input
(nd400♦)
Description
Specifies whether the image when the event occurred should
be attached to the mail.
• Image attachment is not supported when the compression
format specified for the camera image being sent is MPEG-
4.
• Even if [On] is selected here, the image will not be attached
if [Off] is selected for the recording rate setting of event
recording.
Enter the server name or IP address of the SMTP server
sending the mail.
• Enter up to 255 single-byte alpha-numeric characters,
including hyphen (-) and period (.).
• When entering a server name, you must use the DNS.
Specifies the SMTP port number in the range of 1 to 65535.
Enter the server name or IP address of the POP server
receiving the mail.
• Enter up to 255 single-byte alpha-numeric characters,
including hyphen (-) and period (.).
• When entering a server name, you must use the DNS.
Specifies the type of authentication when sending e-mails.
Enter the user name (log in name) used for authentication.
• Enter up to 32 single-byte alpha-numeric characters and
symbols, excluding ampersand (&) and spaces.
Enter the password for the above user name.
• Enter up to 32 single-byte alpha-numeric characters and
symbols, excluding ampersand (&) and spaces.
Specifies destination mail addresses for alarm mail and warning
mail. Up to four addresses can be specified.
Select the check box next to the type of mail (warning/alarm) to
be sent.
• Enter up to 255 single-byte alpha-numeric characters,
including hyphen (-), period (.), at (@), and underscore (_).
Enter the sender's mail address. The address entered here will
appear in the From field of the recipient's mail message.
• Enter up to 127 single-byte alpha-numeric characters,
including hyphen (-), period (.), at (@), and underscore (_).
Server
*1
*1
59