Panasonic WJ-ND400K Setup Instructions page 63

Network settings
Item
NW link down detection
Bandwidth control
Port forwarding
HTTP port number
FTP port number
Network setup - Camera port/Client PC port
DHCP
IP address
Subnet mask
Default gateway
Line speed
Network setup - Maintenance port
IP address
Subnet mask
Static route
DNS setup
DNS
Primary server address
Secondary server address
Settings
Off♦ / On
Unlimited♦ / 32Kbps / 64Kbps /
128Kbps / 256Kbps / 512Kbps /
1024Kbps / 2Mbps / 5Mbps /
10Mbps
Port number input
(80♦)
Port number input
(21♦)
Off♦ / On
*1
Address input
*1
Address input
*1
Address input
Auto♦ / 1000M-Full / 100M-Full /
100M-Half / 10M-Full / 10M-Half
*1
Address input
*1
Address input
Off♦ / Auto / Manual
Address input (0.0.0.0♦)
Address input (0.0.0.0♦)
Description
Specifies whether to detect disconnected network connection of
Camera port/Client PC.
Specifies the maximum rate for data transmitted to the network.
• The transmission amount is not limited in the case of an
MPEG-4 live image.
Specifies whether port forwarding is enabled. To configure this
setting, click the [Setup >>] button.
Sets the HTTP port used when sending images in the range of
1 to 65535. Normally this setting is 80.
• Depending on network settings, changing the HTTP port
number may make communication impossible. If this
happens, contact your network administrator.
• Do not specify any of the following numbers for an FTP port
number, site alarm port number, or port forwarding port
number.
20, 21, 23, 25, 42, 53, 67, 68, 69, 79, 105, 110, 123, 161,
162, 546, 547, 995, 10001, 10002, 10003, 10004, 10005,
10006, 10007
Specifies the recorder FTP port number in the range of 1 to
65535. Normally this setting is 21.
• Do not specify any of the following numbers for an HTTP
port number, site alarm port number, or port forwarding port
number.
20, 23, 25, 42, 53, 67, 68, 69, 79, 80, 105, 110, 123, 161,
162, 546, 547, 995, 10001, 10002, 10003, 10004, 10005,
10006, 10007
Specifies whether a DHCP server is used.
• Select [On] to obtain the IP address, subnet mask, and
default gateway from a DHCP server. Select [Off] to enter
them manually.
When [DHCP] is [Off], specify the IP address here.
When [DHCP] is [Off], specify the subnet mask here.
When [DHCP] is [Off], specify the default gateway here.
Specifies the data line speed.
Specifies the IP address.
Specifies the subnet mask.
Determine whether or not to validate the static route setting. To
configure this setting, click the [Setup >>] button.
Specifies whether a DNS is used.
• Selecting [Auto] enables auto detection of the DNS server.
This setting is available only when [On] is selected for the
[DHCP] setting of the Client PC port (page 61).
• When [Manual] is selected, a primary address and
secondary address can be specified for the DNS server IP
address.
Enter the IP address of the primary DNS server.
Enter the IP address of the secondary DNS server.
Network
63