Snmp - Panasonic WJ-ND400K Setup Instructions

Network

SNMP

Use the following procedure to configure settings for using SNMP (Simple Network Management Protocol). Configure these settings when
connecting to an SNMP manager and check the status of the recorder.
1
Click the [Network] button on the setup menu.
2
On the sub-menu that appears, click [SNMP].
This will display the "SNMP Setup" window.
SNMP settings
Item
Community
System name
Location
Contact
♦Initial default
*1 You can enter the following single-byte alpha-numeric characters and symbols.
A B C D E F G H I J K L M N O P Q R S T U V W X Y Z a b c d e f g h i j k l m n o p q r s t u v w x y z
0 1 2 3 4 5 6 7 8 9 ! # $ % ` ( ) * + , - . / : ; < = > ? @ [ \ ] ^ _ { | } ~
66
Settings
Name input
(Blank♦)
Name input
(Blank♦)
Name input
(Blank♦)
Address input
(Blank♦)
3
Configure the settings for each item.
Refer to "SNMP settings" table for details about the settings.
4
Click the [Set] button.
Description
Enter the community name to be monitored.
• Enter up to 32 single-byte alphanumeric characters and
*1
symbols.
Enter a name to be used by the SNMP system to manage the
recorder.
• You can input up to 255 single-byte alphanumeric characters.
Enter the location of the recorder.
• You can input up to 255 single-byte alphanumeric characters.
Enter contact information (mail address, etc.) for the recorder
administrator.
• You can input up to 255 single-byte alphanumeric characters.