Network Setup - Panasonic WJ-ND400K Setup Instructions

Network setup

This section explains how to configure recorder network settings.
1
Click the [Quick] button on the setup menu.
This will display the setting window.
2
Configure the settings for each item.
Refer to "Quick settings 2" table for details about the settings.
Quick settings 2
Item
Network setup- Camera port/Client PC port
DHCP
IP address
Subnet mask
Default gateway
Line speed
Network setup - Maintenance port
IP address
Subnet mask
♦Initial default
*1 Refer to "Recorder network settings (page 11)" for information on initial default settings.
Important:
• A different subnet should be set for each port.
• When DHCP is set to [On] and "SD memory rec." is set, an error may occur in the process of startup of the unit when a request to write onto
the SD memory card is made. This occurs when the response from the DHCP server is slow. Once the address has been obtained from the
DHCP server, the error is resolved.
Settings
Off♦ / On
*1
Address input
*1
Address input
*1
Address input
Auto♦ / 1000M-Full / 100M-Full /
100M-Half / 10M-Full / 10M-Half
*1
Address input
*1
Address input
3
Under the "Network setup" item, click the [Set] button
When you change the Client PC port IP address, the
"Change IP Address" window will appear. Click [OK] to
complete the process.
Note:
• Changing the "Client PC port" IP address causes all connected
users to be forcibly logged out. Reconnect with the new IP
address.
• The recorder reboots after changing the line speed settings and
pressing [Set].
Description
Specifies whether a DHCP server is used.
Select [On] to obtain the IP address, subnet mask, and default
gateway from a DHCP server. Select [Off] to enter these
addresses manually.
When [DHCP] is [Off], specify the IP address here.
When [DHCP] is [Off], specify the subnet mask here.
When [DHCP] is [Off], specify the default gateway here.
Specifies the data line speed.
Specifies the IP address.
Specifies the subnet mask.
Quick settings
27