Panasonic WJ-ND400K Setup Instructions page 64

Network
Item
Domain name
♦Initial default
*1 Refer to "Recorder network settings (page 11)" for information on initial default settings.
Important:
• A different subnet should be set for each port.
• If DHCP is set to [On] and "SD Memory recording" is set, write requests to the camera's SD memory data may fail at startup. This occurs
because the response from the DHCP server is slow. Once the address has been obtained from the DHCP server, the error is resolved.
Port forwarding
Item
Port forwarding
Port number
♦Initial default
Static route
Item
Static route setting
Address
Subnet mask
Gateway
♦Default
64
Settings
Name input (local domain♦)
Settings
Off / On♦
Port number input
(Camera 1:60001♦ to
camera 64:60064♦)
Parameter
Off♦ / On
Address entry field
(Blank♦)
Subnet mask entry field
(Blank♦)
Gateway entry field
(Blank♦)
Description
Enter the domain name of the recorder.
• Enter up to 255 single-byte alpha-numeric characters,
including hyphen (-) and period (.).
• Use an alphabetic character as the first character of the
domain name.
Description
Specifies whether port forwarding is enabled.
When port forwarding is [On], specifies camera port numbers in
the range of 1 to 65535.
• Do not specify any of the following numbers for an HTTP
port number, FTP port number, site alarm port number, or
port forwarding port number.
20, 21, 23, 25, 42, 53, 67, 68, 69, 79, 80, 105, 110, 123, 161,
162, 546, 547, 995, 10001, 10002, 10003, 10004, 10005,
10006, 10007
Description
Determine whether or not to validate the static route setting.
Configure this setting after considering the network connection
environment of this product.
Enter the destination address.
• The following values are unavailable.
Broadcast address, loop-back address, class D address,
class E address, "000.000.000.000", "111.111.111.111",
and any of the address used for the camera port/client PC
port/maintenance port.
Enter the subnet mask of the destination.
• The following values are unavailable.
Broadcast address, loop-back address, class D address,
class E address, "000.000.000.000", "111.111.111.111",
and any of the address used for the camera port/client PC
port/maintenance port.
Enter the gateway of the destination.
• The following values are unavailable.
Broadcast address, loop-back address, class D address,
class E address, "000.000.000.000", "111.111.111.111", and
any of the address used for the camera port/client PC port/
maintenance port and camera
maintenance port and another network.
port/client PC port