Ftp - Panasonic WJ-ND400K Setup Instructions
Network disk recorder
Hide thumbs
Also See for WJ-ND400K:
- Setup instructions (110 pages) ,
- Installation manual (64 pages) ,
- Quick reference manual (4 pages)
Table of Contents
Advertisement
Server
FTP
Use the following procedure to send images from a camera connected to the recorder to a specified FTP server.
1
Click the [Server] button on the setup menu.
2
On the sub-menu that appears, click [FTP].
This will display the "FTP Setup" screen.
FTP settings
Item
FTP server address
User name
Password
Mode
Image transmission by periodic timer
Server directory
File name
Interval
56
Settings
Address input
(Blank♦)
Name input
(Blank♦)
Enter password
(Blank♦)
Active / Passive♦
Name input
(Blank♦)
Time & date base♦/ Serial number Specify the rules for the file name used for sending images.
Value input
s / min (units)
(1s♦)
3
Configure the settings for each item.
Refer to "FTP settings" table for details about the settings.
4
Click the [Set] button.
Description
Enter the name or IP address of the FTP server where images
are sent.
•
Enter up to 255 single-byte alpha-numeric characters,
including hyphen (-) and period (.).
•
When entering a server name, you must use the DNS.
Enter the user name (log in name) for accessing the FTP
server.
•
Enter up to 32 single-byte alpha-numeric characters and
symbols, excluding ampersand (&) and spaces.
Enter the password for the above user name.
•
Enter up to 32 single-byte alpha-numeric characters and
symbols, excluding ampersand (&) and spaces.
Specifies the mode when sending images to the FTP server.
•
When send is not possible with [Passive], change to [Active].
Set the following items to periodically transmit live images.
Setting whether or not to transmit live images to the FTP server
can be set for scheduled time periods with "Time table
(page 46)".
Enter the send destination directory.
•
Enter up to 255 single-byte alpha-numeric characters and
symbols, excluding &*:<>?\|~ and spaces.
Specifies the interval for image transmission by periodic timer.
•
Enter a number (0.1 - 0.9 (in steps of 0.1 sec.), 1-1440) for
transmission interval, and select "s" (seconds) or "min"
(minutes) for the transmission interval.
•
Select either [s] (seconds) or [min] (minutes) as the time
unit.
•
When selecting "s", 0.1 - 0.9 (0.1, 0.2, 0.3, 0.4, 0.5, 0.6, 0.7,
0.8, 0.9) are available.
Advertisement
Table of Contents
