Terminal Alarm - Panasonic WJ-ND400K Setup Instructions

Terminal alarm

Use the following procedure to configure settings the control alarm action when a terminal alarm occurs.
For information on how to register preset positions for the camera, refer to the Operating Instructions.
1
Click the [Event] button on the setup menu.
2
On the sub-menu that appears, click [Terminal alarm].
This will display the terminal alarm setting window.
Terminal alarm settings
Item
Rec. cam.
Preset position
Output terminal
♦Initial default
Settings
Cam.1 to Cam.64 / --
Number input
(Blank♦)
Off / On♦
3
Configure the settings for each item.
Refer to "Terminal alarm settings" table for details about the
settings.
• To configure the settings of a terminal that is not shown
on the display, click the terminal number range above the
[Set] button to change the contents of the window.
• Clicking a terminal number range will save the currently
displayed camera settings.
4
Click the [Set] button.
Description
Specifies the channel of the recording camera.
Specifies the preset position (1 to 256) during alarm input.
• When this setting is blank, the camera does not move to a
preset position.
Specifies whether an alarm signal should be output when an
event occurs.
Event
39