HP ML330 - ProLiant - G3 Setup And Installation Manual page 113

Server Specific Troubleshooting
When the server does not start:
1. Be sure that the server and monitor are plugged into a working outlet.
2. Be sure that the power source is working properly:
— Check the status using the system power LED.
For the location and status of the system power LED, refer to Chapter 1,
"Component Identification."
— Be sure that the Power On/Standby button was pressed firmly.
For details on what else to check, refer to the Servers Troubleshooting Guide.
3. If the server does not complete POST, or it does complete POST but does not
load the operating system, refer to the Servers Troubleshooting Guide.
NOTE: If the server is rebooting repeatedly, be sure that the server is not restarting due
to an Automatic Server Recovery-2 (ASR-2) power-up caused by another problem. Check
Insight Manager 7 for notification of this event. Refer to the Servers Troubleshooting
Guide for more information.
4. Restart the server.
5. Check for the following normal power-up sequence to be sure that the server
meets the minimal hardware requirements and is powered up under normal
operation:
a. The front panel system power LED turns green.
b. The fans start up.
D-2 HP ProLiant ML330 Generation 3 Server Setup and Installation Guide