Mouse Compliance Statement - HP ML330 - ProLiant - G3 Setup And Installation Manual

The power cord must be rated for the product and for the voltage and current marked
on the product's electrical ratings label. The voltage and current rating of the cord
should be greater than the voltage and current rating marked on the product. In
addition, the diameter of the wire must be a minimum of 1.00 mm² or 18AWG, and
the length of the cord must be between 1.8 m (6 feet) and 3.6 m (12 feet). If you have
questions about the type of power cord to use, contact your authorized service
provider.
IMPORTANT: Route power cords so that they will not be walked on or pinched by items
placed upon or against them. Pay particular attention to the plug, electrical outlet, and the point
where the cords exit from the product.

Mouse Compliance Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
HP ProLiant ML330 Generation 3 Server Setup and Installation Guide
Regulatory Compliance Notices
A-9