HP ML330 - ProLiant - G3 Setup And Installation Manual page 69

Hardware Options Installation
IMPORTANT: Always use the SCSI cable that ships with the drive cage option kit. Other
available SCSI cables may not support Ultra3 SCSI.
8. Connect the SCSI cable that ships with the optional drive cage to the SCSI
connector on the back of the drive cage.
9. Thread the SCSI cable through the media bay.
10. Locate the power cable inside the server and connect it to the power connector on
the back of the drive cage.
11. Install the drive cage:
a. Slide the drive cage into the removable media bay until it locks into place.
b. Screw the ends of the rails into the chassis on both sides.
4-26 HP ProLiant ML330 Generation 3 Server Setup and Installation Guide