HP ML330 - ProLiant - G3 Setup And Installation Manual page 129

Battery Replacement
4. Locate the battery on the system board. Refer to Chapter 1, "Component
Identification."
NOTE: If you have expansion boards installed, it may be necessary to remove them to
gain access to the battery. Refer to Chapter 4, "Hardware Options Installation."
5. Remove the battery:
a. Press outward on the latch at the top of the battery holder to release the
battery.
b. Lift the battery away from the holder.
To replace the component, reverse the removal procedure.
IMPORTANT: Replacing the system board battery resets the system ROM to its default
configuration. After replacing the battery, reconfigure the system through RBSU. Refer to
Chapter 5, "Server Configuration and Utilities."
For more information about battery replacement or proper disposal, contact the
authorized reseller or authorized service provider.
F-2 HP ProLiant ML330 Generation 3 Server Setup and Installation Guide