System Configuration Reset - HP ML330 - ProLiant - G3 Setup And Installation Manual

Server Specific Troubleshooting
Table D-8: Server Cannot Load the Operating System
Possible Cause
The primary hard drive controller installation is
incorrect.
The hard drive controller order is incorrect.
Problem was encountered with the hardware
you have added to the system.
Problem was encountered with hardware added
to a new configure-to-order system (where
available).
Note: For complete instructions on the use of RBSU, refer to Chapter 5, "Server Configuration and
Utilities," or refer to the HP ROM-Based Setup Utility User Guide.

System Configuration Reset

It may be necessary at some time to clear and reset system configuration settings.
When the system configuration switch position 6 is set to the On position, the server
is prepared to erase all system configuration settings from both CMOS and NVRAM.
CAUTION: Clearing nonvolatile RAM (NVRAM) deletes the system configuration.
For instructions on configuring the server, refer to Chapter 5, "Server Configuration
and Utilities."
To reset system configuration settings:
1. Power down the server. Refer to Chapter 2, "Server Operations."
2. Remove the front bezel. Refer to Chapter 2, "Server Operations."
3. Remove the access panel. Refer to Chapter 2, "Server Operations."
4. Set the system configuration switch position 6 to the On position.
D-12
Possible Solution
Run RBSU by pressing the F9 key and correct
this problem.
Refer to the documentation provided with the
hardware.
You must complete the factory-installed
operating system software installation before
adding new hardware to the system.
Be sure you are following the instructions
provided in the HP Factory-Installed Operating
System Software Installation Guide.
Remove the new hardware and complete the
software installation. Then, reinstall the new
hardware.
HP ProLiant ML330 Generation 3 Server Setup and Installation Guide
continued