HP ML330 - ProLiant - G3 Setup And Installation Manual page 78

Server Configuration and Utilities
Server Asset Text
The Server Asset Text menu customizes the server-specific text, including the
following:
•
Set Server Information Text defines reference information for the server, such
as Server Name, Server Asset Tag, Server Primary OS, and Other Text.
•
Set Administrator Information Text defines reference information for the
server administrator, such as Admin Name Text, Admin Phone Number Text,
Admin Pager Number Text, and Other Text.
•
Set Service Contact Text defines reference information for the service contact
of the server, such as Service Name Text, Service Phone Number Text,
Service Pager Number Text, and Other Text.
•
Serial Number allows you to change the chassis serial number.
Advanced Options Menu
The Advanced Options menu enables you to configure advanced options of the
system. The following selections are available on this menu:
•
MPS Table Mode is automatically set based on the operating system selected
and is used for interrupt routing. By default, this setting is Auto Set Table.
•
POST Speed Up quickens POST by disabling the extended power-up memory
test. By default, this setting is Enabled.
•
POST F1 Prompt configures the server so that when an error is encountered
during the power-up sequence, you must press the F1 key to proceed (Enabled
option) or the system pauses 10 seconds before proceeding (Delayed option).
The F1 Prompt option can also be Disabled. By default, this setting is Delayed.
•
Redundant ROM Selection toggles the server ROM between the current ROM
and the backup ROM.
•
Erase Non-volatile Memory resets the non-volatile memory of the server to an
initial, factory state.
5-6 HP ProLiant ML330 Generation 3 Server Setup and Installation Guide