Problems After Initial Power Up; Table D-6: System Cannot Load Smartstart - HP ML330 - ProLiant - G3 Setup And Installation Manual

Problems After Initial Power Up

After the server has passed POST, you may still encounter errors, such as an inability
to load the operating system.
NOTE: If the server is rebooting repeatedly, be sure that the server is not restarting due to an
Automatic Server Recovery-2 (ASR-2) power-up caused by another problem. Check Insight
Manager for notification of this event. Refer to the Servers Troubleshooting Guide for more
information.
Refer to the Servers Troubleshooting Guide for the following:
•
Information you must collect when diagnosing software problems and to provide
when contacting support
•
Instructions on how to upgrade the operating system and its drivers
•
Information on available recovery options and advice on minimizing downtime
Use the tables in this section to troubleshoot server installation problems that occur
after the initial startup.

Table D-6: System Cannot Load SmartStart

Possible Cause
A SmartStart requirement is not met.
The wrong version of SmartStart is being
installed.
HP ProLiant ML330 Generation 3 Server Setup and Installation Guide
Server Specific Troubleshooting
Possible Solution
Check the SmartStart Release Notes provided
in the SmartStart Online Reference Information
on the SmartStart CD.
Refer to the HP website to check the version of
SmartStart.
continued
D-9