The Rear Panel - At A Glance - Agilent Technologies N5700 Series User Manual

1 Quick Reference
The Rear Panel – At a Glance
GPIB
J2 SW1
ON
OFF
1 2 3 4 5 6 7 8 9 ANALOG PROGRAMMING
+S+LS NC -LC-S
7 6
1 – AC input connector
2 – DC output connector
3 – USB connector
4 – LAN connector
5 – Analog Programming
connector
6 – SW1 setup switch
7 – Remote Sense connector
8 – GPIB connector
9 – Ground screw
WARNING
12
8
10/100 Ethernet
!
LINK TX
+V
J1
NOT ACTIVE
80V - 600V
3
5 4
6V - 60V
Wire clamp connector for 1500W output models.
IEC connector for 750W output models.
Wire clamp connector for 80V to 600V models.
Bus bars for 6V to 60V models.
Connector for connecting to a USB interface. See chapter 4 for setup.
Connector for connecting to a LAN interface. LINK LED indicates link integrity.
TX LED indicates LAN activity. See chapter 4 for LAN setup.
Connector for the analog interface. Includes output voltage and current limit
programming and monitoring signals, Shut-Off control (electrical signal),
Enable/Disable control (dry-contact), power supply ok (Power Supply OK) signal
and operation mode (CV/CC) signal. (See next page for details)
Nine-position switch for selecting remote programming and monitoring modes
for Output Voltage, Current Limit and other control functions. (See next page for
details)
Connector for making remote sensing connections for regulating the load
voltage and compensating for wiring voltage drop. (See next page for details)
Connector for connecting to a GPIB interface. See chapter 4 for setup.
M4x8 screws for making chassis ground connections
SHOCK HAZARD The power cord provides a chassis ground through a third
conductor. Be certain that your power outlet is of the three-conductor type
with the correct pin connected to earth ground
9
-V
2
!
AC INPUT
750W
1
1500W
Series N5700 User's Guide