Agilent Technologies N5700 Series User Manual page 131

Manual Updates
LXI-compliant units
(see page 10 for additional details)
DC AMPS
OCP/488 LAN OUT ON
11 9
10
12
9 – LAN View address: Press LAN to view the IP
button and Ethernet address.
Reset address: Press and hold the LAN
button for three seconds. Pressing the
LAN button again while "LAn rES" is
displayed resets the LAN configuration
to the factory-shipped settings.
10 – LAN When lit, indicates that the LAN has
indicator been configured and is operating
normally. When blinking, identifies the
unit for which the indicator has been set
to blink by the unit's Web home page.
11 – OCP/488 Enable OCP: Press OCP/488 to turn
button over-current protection (OCP) on. Press
again to turn OCP off.
Reset OCP: When an over-current
protection event occurs, press the OUT
ON button to enable the output and re-
arm over-current protection.
GPIB address: Press and hold the
OCP/488 button for three seconds to set
the address with the Voltage knob.
12 – OCP When lit, indicates that over-current
indicator protection is enabled or on.
11/08/07 The following documents the differences between front
panel operation of the LXI-compliant units and the pre-LXI units.
CURRENT
CC
2/18/09 On page 28, information has been added under "Grounding
the Output".
9/28/10 On page 28, information has been added about battery
charging.
Pre-LXI units
DC AMPS
OCP REM OUT ON
11 9
10
12
9 – REM Mode function: Press REM to put the
button unit into local mode. This function is
not available in LXI compliant units.
Address function: Selects the GPIB
address. Press and hold the REM
button for three seconds to set the
address with the Voltage knob.
10 – REM When lit, indicates that the unit is in
indicator Remote mode. This function is not
available in LXI compliant units.
11 – OCP Enable function: Press OCP to turn
button over-current protection (OCP) on.
Press again to turn OCP off.
Reset OCP: When an over-current
protection event occurs, press the
OUT ON button to enable the output
and re-arm over-current protection.
12 – OCP When lit, indicates that over-current
indicator protection is enabled or on.
CURRENT
CC