Agilent Technologies N5700 Series User Manual page 120

Appendix C Service
−141
−144
−148
−150
−151
−158
−160
−161
−168
−170
−171
−178
−200
−220
−221
−222
−223
−224
−225
−226
−230
120
Command Errors (continued)
Invalid character data
Either the character data element contains an invalid character, or the element is not valid.
Character data too long
The character data element contains more than 12 characters.
Character data not allowed
A discrete parameter was received, but a string or numeric parameter was expected.
String data error
Generic string data error
Invalid string data
An invalid character string was received. Check that the string is enclosed in quotation marks.
String data not allowed
A character string was received, but is not allowed for this command.
Block data error
Generic block data error
Invalid block data
The number of data bytes sent does not match the number of bytes specified in the header.
Block data not allowed
Data was sent in arbitrary block format but is not allowed for this command.
Expression error
Generic expression error
Invalid expression data
The expression data element was invalid.
Expression data not allowed
Expression data element was sent but is not allowed for this command.
Execution Errors (these errors set Standard Event Status register bit #4)
Execution error
Generic syntax error
Parameter error
A data element related error occurred.
Settings conflict
A data element could not be executed because of the present instrument state.
Data out of range
A data element could not be executed because the value was outside the valid range.
Too much data
A data element was received that contains more data than the instrument can handle.
Illegal parameter value
An exact value was expected but not received.
Out of memory
The device has insufficient memory to perform the requested operation.
Lists not same length
One or more lists are not the same length.
Data corrupt or stale
Possible invalid data. A new reading was started but not completed.
Series N5700 User's Guide