Agilent Technologies N5700 Series User Manual page 126

Appendix D Compatibility
Compatibility Command
OVP
OVP?
RCL <reg>
ROM?
RST
SRQ <setting>
SRQ?
STO <reg>
STS?
TEST?
TRG
UNMASK <setting>
UNMASK?
VMAX
VMAX?
VOUT?
VSET <voltage>
VSET?
126
Description
Sets the over-voltage trip point.
Queries the present over-voltage setting. The response is a real number.
Recalls the saved settings. There are up to 16 store/recall states. Saved
settings must have been previously stored using the STO command.
Queries the revision date of the power supply's firmware.
Resets any tripped protection.
Generates error 203. The service request capability of the power supply is
only supported using the SCPI commands
Always returns 0.
Stores the present power supply settings in the specified register. There are
up to 16 store/recall states.
Queries the present status. The response represents the sum of the binary
weights of the status register bits. The response is STS <n>
Always returns 0.
Causes the settings held with HOLD 1 to be executed.
Sets the bits in the mask register to the setting. The setting is an integer
that represents the sum of the binary weights of the bits. The mask register
operates in conjunction with the status and fault registers.
Queries the present setting of the mask register. The response is UNMASK
<n>.
Sets the soft programming limit for voltage. Attempting to program the
voltage above this setting will generate an error.
Queries the VMAX setting. The response is VMAX <n>.
Queries the measured output voltage. The response is a real number.
Sets the output voltage.
Queries the present voltage setting. The response is a real number.
Similar SCPI
Command
VOLT:PROT:LEV
VOLT:PROT:LEV?
*RCL
*IDN?
OUTP:PROT:CLE
*SRQ
*SRQ?
*SAV
STAT:OPER:COND?
STAT:QUES:COND?
*TST?
STAT:OPER:NTR
STAT:OPER:PTR
STAT:QUES:NTR
STAT:QUES:PTR
STAT:OPER:NTR?
STAT:OPER:PTR?
STAT:QUES:NTR?
STAT:QUES:PTR?
MEAS:VOLT?
VOLT
VOLT?
Series N5700 User's Guide