Agilent Technologies N5700 Series User Manual page 85

' Set the voltage
.WriteString "VOLT" & Str$(VoltSetting)
' Set the current level
.WriteString "CURR " & Str$(CurrSetting)
' Set the triggered voltage and current levels
.WriteString "VOLT:TRIG " & Str$(trigVoltSetting)
.WriteString "CURR:TRIG " & Str$(trigCurrSetting)
' Turn the output on
.WriteString "OUTP ON"
' Make sure that the output is on
.WriteString "*OPC?"
.ReadString
' Measure the voltage before triggering the change
.WriteString "MEAS:VOLT?"
MeasureVolt = .ReadNumber
' Save the value for later display
msg1$ = "Voltage before trigger = " & Str$(MeasureVolt)
' Initiate the trigger system
.WriteString "INIT"
' Make sure that the trigger system is initiated
Do
.WriteString "STAT:OPER:COND?"
stat = .ReadNumber
Loop Until ((stat And WTG) = WTG)
' Trigger the unit
.WriteString "*TRG"
'Make sure that the trigger is done
.WriteString "*OPC?"
.ReadString
' Measure the voltage after triggering the change
.WriteString "MEAS:VOLT?"
MeasureVolt = .ReadNumber
' Display the measured values
MsgBox msg1$ + Chr$(13) + "Voltage after trigger = " & Str$(MeasureVolt)
' Check instrument for any errors
.WriteString "Syst:err?"
ErrString = .ReadString
' Give message if there is an error
If Val(ErrString) Then
MsgBox "Error in instrument!" & vbCrLf & ErrString
End If
End With
End Sub
Series N5700 User's Guide
Programming Examples 6
85