Installing Accessory Boards - HP LC2000r - NetServer - 128 MB RAM User Manual

Chapter 4
The ISA Board Slot, which accepts a single ISA board. This slot is shared
with PCI slot 1. Either slot can be occupied, but not both.
The two SCSI connectors, A and B, which are separate channels that
control the disk arrays in the right (standard) and left (optional) hot-swap
mass storage cages, respectively. The base configuration of the NetServer
has one hot-swap mass storage cage on the right side, controlled by a
connection to SCSI connector A. By default, this disk array is controlled
by the integrated HP NetRAID controller.
Remote
I/0 Memory
Management
PCI Board
Slots
Figure 4-2. I/O Board With Devices and Bus Structure
NOTE
For a list of boards HP has tested with the NetServer, see the
Help topic "Tested Parts List" on the HP NetServer Navigator
CD-ROM.

Installing Accessory Boards

Remove the NetServer's cover: (See Chapter 3, "Removing and Replacing
Covers.")
To install accessory boards:
1. Read the documentation included with each accessory board. Follow any
special instructions and installation recommendations. Some boards have
18
Installing Accessory Boards
SE SCSI
ISA Board Slot
SCSI B
SCSI A