Rear Panel Controls, Ports, And Indicators - HP LC2000r - NetServer - 128 MB RAM User Manual

Chapter 2

Rear Panel Controls, Ports, and Indicators

Refer to Figure 2-2 below to locate features on the NetServer's rear panel:
The Remote Management Port links the NetServer to a console for real-
time diagnosis of system operation.
The Serial B Port is a standard serial port.
The Serial A Port is a standard serial port.
The Parallel Port is a standard parallel port.
The Mouse Port accepts a standard PC mouse.
The Keyboard Port accepts a standard PC keyboard.
The Monitor Port accepts a monitor with up to 1024 x 768 x 256
resolution, with a 60-75Hz video refresh rate. The NetServer contains
1MB of video RAM.
The NetServer comes with two 550W power supplies installed on the left
rear. The optional Redundancy Kit provides a power supply and power
supply cage for installation on the right rear. Since the NetServer only
requires two power supplies to run, installing a third power supply
prevents service interruptions from a single power supply failure. With the
Redundancy Kit installed a new power supply can be hot-swapped in.
The Power Connector accepts a standard power cable to connect the
NetServer with the site AC power source.
6
Controls, Ports, and Indicators