HP LC2000r - NetServer - 128 MB RAM User Manual page 27

Chapter 4
preferred slot locations. If not, consider the boot order (see Figure 4-3)
when choosing the accessory board socket in which to install the board.
Figure 4-3. Accessory Board PCI and ISA Slots
Boot order for PCI controllers is determined by slot location. The system
searches for a bootable device in the following order:
1. IDE CD-ROM drive with a bootable CD-ROM.
2. Flexible disk drive with a bootable flexible disk.
3. Embedded SCSI controller or embedded DAC.
4. PCI boards in slots in the following order: 8, 7, 6, 5, 4, 3, 2, 1.
This boot order can be changed using the SETUP utility (press [F2]
during the boot process).
2. Remove the slot cover for each slot to be used, and store it for future use.
If you are installing any full-length PCI boards, also remove the accessory
board retainer. Push on the tab on the retainer to release it, and then slide
it out of the board guide.
Installing Accessory Boards
19