Memory; Boot Device Priority - HP LC2000r - NetServer - 128 MB RAM Handbook

Memory

There are four DIMM sockets on the system board for memory expansion. You can use 64 MB, 128 MB, and
256 MB DIMMs for a maximum capacity of 1 GB of RAM.
The minimum memory configuration for the NetServer LH 3/LH 3r is one 128 MB DIMM.
The system board DIMM sockets are numbered from 0 to 3.
DIMMs may be installed in any quantity and in any DIMM socket on the system board. DIMMs that
differ in capacity can be mixed.
CAUTION

Boot Device Priority

Slot 1 16-bit ISA or 32-bit PCI
Slot 2 32-bit PCI
Slot 3 32-bit PCI
Slot 4 32-bit PCI
Slot 5 32-bit PCI
Slot 6 32-bit PCI
Slot 7 32-bit PCI
Slot 8 32-bit PCI
Boot order for PCI controllers is determined by slot location. The system searches for a bootable device in
the following order:
1. IDE CD-ROM drive with a bootable CD-ROM.
2. Flexible disk drive with a bootable flexible disk.
3. Embedded SCSI controller or embedded DAC.
4. PCI boards in slots in the following order: 8, 7, 6, 5, 4, 3, 2, 1.
94
Do not rock the DIMM into place, but apply firm and even pressure directly
downward. If the retaining clips do not close, remove the module and repeat Steps 3
through 5.