Configuring Switch Settings On The Hot Swap Subsystem - HP LC2000r - NetServer - 128 MB RAM Handbook

Duplex Disk Array Configuration with Dual Channel PCI Controller Board
This is one of several possible optional mass storage configurations. You are not limited to the configurations
shown on this CD-ROM; this is only given as an example.
Channel 1
PCI DAC Board
Default Switch Settings
On
Off
1
2
ID
3
1
4
5
6

Configuring Switch Settings on the Hot Swap Subsystem

Switches 3 and 4 determine the SCSI address of each of the shelves. Possible switch settings are given in
the table below.
SCSI Terminator
built into cable
IDE IDE
System Board
SCSI A
Channel 0
connector
I C
2
This is the default SCSI switch setting for this configuration.
SCSI ID 2 is reserved for an optional DAT (Digital Audio Tape)
drive that can be installed in upper shelf 3 or 4. The standard
CD-ROM drive is shipped with SCSI ID 5.
ID ID
0 3
Flexible Disk
T
SCSI or IDE
C31
SCSI or IDE
68-Pin
to
A
50-Pin
Adapter
C22
B1
(Rear View)
C22
Drive
CD-ROM
Device
Device
37