Cabling Configurations - HP LC2000r - NetServer - 128 MB RAM Handbook

NOTE

Cabling Configurations

Duplex, Non-Disk Array Model with Internal Controller
This is a standard mass storage configuration as shipped from HP.
NOTE
Default Switch Settings
On
Off
1
2
ID ID
3
1 0
4
5
6
36
In order to optimize PCI board BIOS installation, you need to leave the largest open
range of memory possible. Group the EISA and ISA board BIOSs at either the
beginning or end of the 0C8000h through 0DFFFFh range.
If you are installing Ultra SCSI mass storage devices in this NetServer, you must
enable Ultra SCSI.
SCSI Terminator
built into cable
IDE
System Board
SCSI A
Connector
I C
2
This is the default SCSI switch setting for this configuration.
SCSI ID 2 is reserved for an optional DAT (Digital Audio Tape)
drive that can be installed in upper drive tray 3 or 4. The
standard CD-ROM drive is shipped with SCSI ID 5.
ID
3
Flexible Disk
Drive
T
CD-ROM
SCSI or IDE
Device
SCSI or IDE
Device
C31
B1
(Rear View)
C22