Dc Power Converter; Smart Array 5I Plus Memory Module - HP ProLiant BL40p Maintenance And Service Manual

DC Power Converter

Refer to the label on the DC power converter for removal instructions.

Smart Array 5i Plus Memory Module

To remove the Smart Array 5i Plus memory module:
1. Power down the server blade and remove it from the server blade enclosure. Refer to the
"Server Blad e Preparation" section in this chapter.
2. Remove the access panel. Refer to the " Access Panel" section in this chapter.
3. Remove the DC power converter from the system board. Refer to the label on the DC
power converter.
4. Disconnect the Battery-Backed Write Cache Enabler cable, if the option is installed.
IMPORTANT: If the data in the Smart Array 5i Battery-Backed Write Cache Enabler needs to be
saved, do not disconnect the battery module cable.
5. Pull out the levers on either side of the memory module (1).
6. Lift out the memory module at a 45° angle (2).
Figure 2-23: Removing the Smart Array Plus memory module
Reverse steps 1 through 6 to replace the Smart Array Plus memory module.
HP ProLiant BL40p Server Blade Maintenance and Service Guide
Removal and Replacement Procedures
2-23