Boot Device Priority - HP LC2000r - NetServer - 128 MB RAM Handbook

Hp netserver service handbook, volume 2 - mid
Hide thumbs Also See for LC2000r - NetServer - 128 MB RAM:
Table of Contents

Advertisement

LED Processor Error Codes
Alternating LED Codes:
LED LED LED LED
0
1
2
ON-OFF-OFF-ON &
OFF-ON-ON-OFF
OFF-OFF-ON-ON &
ON-ON-OFF-OFF
ON-OFF-OFF-OFF &
OFF-ON-ON-ON
OFF-ON-OFF-OFF &
ON-OFF-ON-ON
OFF-OFF-OFF-ON &
ON-ON-ON-OFF
NOTE

Boot Device Priority

The following is the search path in order of the highest boot device priority:
1. CD-ROM drive with bootable CD-ROM
2. Flexible disk drive with bootable flexible disk
3. IDE drive
4. The first mass storage device attached to the EISA, ISA or PCI (embedded or added) controller
set to the lowest BIOS address. The lowest BIOS address is usually C8000h.
To Boot From a PCI Controller Board
Systems with only PCI boards (No EISA or ISA Boards)
Your system uses the following default PCI boot priority order:
1. Embedded SCSI A
2. PCI slots in the following order: 9, 8, 7, and 6.
If you have drives attached to the SCSI A connector, you must change the PCI boot priority order in the EISA
Configuration Utility so that the PCI slots precede SCSI A:
To change the PCI boot priority order, perform the following:
1. Go to the EISA Configuration Utility.
2. Select "Step 3: View or edit details."
3. Select "PCI SCSI Boot Priority Order" and press Enter.
4. Set to "PCI adapters before SCSI A" and press Enter.
5. Exit and save the configuration.
Systems with PCI and EISA or ISA boards
34
3
Definition
Processor chip
overtemperature
Primary processor chip
(processor #1) not installed
Primary Voltage Regulator
Module fault
Secondary Voltage
Regulator Module fault
System bus regulator fault
If the processor overtemperature error is not corrected within a few minutes, the
system will shut down automatically to avoid damage. To recover from this condition,
wait for the system to cool down (20-25 minutes) and press the Reset button.
Action
Check fans for function. Wait for system to
cool down (20-25 minutes) and press the
Reset button
Install processor chip in primary socket
Replace primary
Voltage Regulator Module
Replace secondary Voltage Regulator
Module
Replace processor board

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents