System Switches And Jumper Descriptions - HP LC2000r - NetServer - 128 MB RAM Handbook

System Switches and Jumper Descriptions

Remote Assistant Connector J25
This connector is used by the HP Remote Assistant Accessory, a 32-bit EISA Bus Master board used to
remotely monitor server functionality. For additional information on this product, see the documentation that
comes with it. When you install the HP Remote Assistant cable, you will need to remove the jumper on PS
REMOTE and PS ON. If you remove HP Remote Assistant from the server, remember to re-install the
jumper.
WARNING
System Board Switch SW1
Switch
1 FLASH WRITE ENABLE: Enables or disables one of the two levels of flash
ROM write protection (the other level of protection is controlled by the HP
Update Utility).
ON: The BIOS can be updated by the HP Update Utility.
OFF: The BIOS is locked and cannot be updated.
2 BOOT BLOCK DISABLE: Reserved. Must be set to ON for system to
operate properly.
If the HP Remote Assistant is not installed and there is no jumper on PS REMOTE
and PS ON, the system will NOT power up.
HP Remote Assistant
Connector
SW1 Default Settings:
Off On
Flash W rite Enable
1
2 Boot Lock Disable
3 Config Valid
Config Unlock
4
Password Enable
5
6
NMI LOG Enable
IO Control Enable
7
Video Enable
8
Function Default
ON
ON
31