Control Panel Description; Control Panel Connector J1 - HP LC2000r - NetServer - 128 MB RAM Handbook

Control Panel Description

Hard Disk Activity Light 1
Yellow = Embedded SCSI A
or IDE bus active
Power-On Light
Green = Power is on
Power Button
Reset Button
Power Button
Power-On Light
Reset Button
Hard Disk Activity Light 1
Hard Disk Activity Light 2
Keyboard Lock Button
Keyboard Lock Light
LCD

Control Panel Connector J1

This connector is used by the HP Remote Assistant Accessory, a 32-bit EISA Bus Master board used to
remotely monitor server functionality. For additional information on this product, see the documentation that
comes with it. When you install the HP Remote Assistant cable, you will need to remove the jumper on PS
REMOTE and PS ON. If you remove HP Remote Assistant from the server, remember to re-install the
jumper.
WARNING
144
Turns the NetServer on and off. Note that when the NetServer is
turned off, the power to the internal circuitry and mass storage
devices is disabled; however, AC power is still applied to the power
supply. Always disconnect the power cord before removing the
cover.
Turns green when the NetServer is on.
Restarts the NetServer. You can press this button if the NetServer
" hangs" or " locks up" — it has the same effect as turning the
NetServer off and on. Save any work before pressing the reset
button. Any information not saved is lost when the NetServer resets.
Yellow indicates activity on the Embedded SCSI A bus or IDE bus.
Yellow indicates activity on the Embedded SCSI B bus.
Prevents unauthorized use of the keyboard. Press the keyboard lock
button to lock the keyboard. Enter the password to unlock the
keyboard.
Turns yellow when the keyboard is locked.
Displays the Power-On Self-Test (POST) or system messages.
If the HP Remote Assistant is not installed and there is no jumper on PS REMOTE
and PS ON, the system will NOT power up.
Hard Disk Activity Light 2
Yellow = Embedded SCSI
B bus active
Keyboard Lock Light
Yellow = Keyboard
is locked
Keyboard Lock Button
LCD