Remote Wakeup And Remote Shutdown - Compaq AP200 - Professional - 128 MB RAM Reference Manual

For more information about the Remote Management Setup software and
enabling Remote Security Management, refer to the online Remote
Management Administrators Guide. The Remote Management Administrators
Guide is included with the Remote Management Administration Tools, and is
available in the Support Software CD kit or at the Compaq website
(http://www.compaq.com).

Remote Wakeup and Remote Shutdown

Your workstation has a network card installed that supports the Compaq
Remote Wakeup and Remote Shutdown functions. These functions allow a
system administrator to power on and power off a client workstation from a
remote location, supported by PC LAN management tools.
NOTE: Third-party software tools are required to remotely distribute software.
Remote Wakeup allows the network interface controller to continue
functioning, even when power to the workstation has been turned off.
NOTE: The workstation continues to consume a small amount of electricity
even after you turn it off. Only when you disconnect the power cord from the
electrical outlet does the workstation stop consuming electricity.
To enable Remote Wakeup and Remote Shutdown, complete the following
steps:
1. Double-click the Network Icon, located in the Control Panel.
2. Double-click the appropriate network controller.
3. Click the Advanced Properties tab.
4. Select Remote Wakeup.
5. Change the value to ON.
6. Click OK to save and apply changes, then click OK to exit the Network
dialog.
Compaq Professional Workstation AP200 Reference Guide
3-21