Table of Contents
Advertisement
Disabling a Serial Port or Parallel Port
To disable either of the serial ports or the parallel port, follow these steps:
1.
Turn on the workstation.
2.
When you see the words "F10=Setup" in the bottom-right corner of
the screen, press F10.
NOTE: You have approximately two seconds to press F10. If you do not press
F10 during this time, you must turn the workstation off, then on again to
access the utility.
3.
Press Enter to bypass the welcome screens and display the main menu.
4.
From the main menu, select Computer Setup, then press Enter.
5.
From the Computer Setup main menu, select Advanced, then Onboard
Devices.
6.
Select the Serial or Parallel Port you wish to disable.
7.
Use the arrow keys to select the disable setting.
8.
Save the configuration and exit the utility.
9.
Restart the workstation.
Compaq Professional Workstation AP200 Reference Guide
3-9
Advertisement
Table of Contents
Troubleshooting
