Upgrading Graphics Capabilities - Compaq AP200 - Professional - 128 MB RAM Reference Manual

9. Plug the network cable back into the system. Plug the power cord back
into the grounded AC outlet and reconnect external devices.
10. Reconfigure the workstation, if necessary. See the "When to
Reconfigure the Workstation" section in this chapter.

Upgrading Graphics Capabilities

To upgrade graphics memory, follow the steps below:
1. Turn off the workstation and any external devices, then disconnect the
power cord from the grounded AC outlet. Disconnect the network
cable and any external devices from the system.
IMPORTANT: On a power-managed system, the power cord MUST be
disconnected from the grounded AC outlet.
2. Remove the workstation access panel.
3. Remove the screw that secures the AGP graphics board to the
workstation chassis and remove the board from the AGP slot.
Figure 4-13.
CAUTION: Static electricity can damage the electronic
components of the workstation or optional equipment. Before
beginning these procedures, ensure that you are discharged of
static electricity by briefly touching a grounded metal object. See
Appendix B for more information.
Removing the Graphics Board from the AGP Slot
Compaq Professional Workstation AP200 Reference Guide
4-17