Table of Contents
Advertisement
4-18
Hardware Upgrades
4.
Place the graphics board on a grounded, flat surface and install the
memory module so that its notch aligns with the tab in the socket at a
30 degree angle, then lower the module until it latches into position.
Figure 4-14.
5.
Reinstall the graphics board into the same slot and secure it with the
screw.
6.
Replace the workstation access panel.
7.
Plug the network cable back into the system. Plug the power cord back
into the grounded AC outlet. Reconnect external devices.
8.
Reconfigure the workstation, if necessary. See the "When to
Reconfigure the Workstation" section in this chapter.
9.
Change the resolution to take advantage of the additional display
modes now available with the upgraded memory. See the following
section, "Customizing the Monitor Display," for more information.
Installing an upgrade memory module on the graphics board
1
2
Advertisement
Table of Contents
Troubleshooting
