Compaq AP200 - Professional - 128 MB RAM Reference Manual page 117

Solving Network Problems
Problem
Diagnostics reports a
failure
Diagnostics passes, but
the workstation does not
communicate with the
network
Continued
Cause
System cannot autosense
the network.
The cable is not securely
connected.
The cable is attached to the
incorrect connector.
There is a problem with the
cable or a device at the
other end of the cable.
The network controller is
defective.
Network controller interrupt
with an expansion board.
Network driver is not loaded,
or driver parameters do not
match current configuration.
Compaq Professional Workstation AP200 Reference Guide
Solution
Disable autosensing
capabilities and force the
system into the correct
operating mode. See Chapter
3, "Intelligent Manageability."
Ensure that the cable is
securely attached to the
network connector and that
the other end of the cable is
securely attached to the
correct device.
Ensure that the cable is
attached to the correct
connector.
Ensure that the cable and
device at the other end are
operating correctly.
Contact your Compaq
authorized service provider.
Under the Computer Setup
Advanced menu, change the
resource settings for the
board.
Make sure the network driver
is loaded and that the driver
parameters match the
configuration of the network
controller.
Continued
6-15