Changing Functions Using The Dip Switches; Operation Panel Dip Switches - Brother LK3-B434E MKII Instruction Manual

12. CHANGING FUNCTIONS USING THE DIP SWITCHES

12-1. Operation panel DIP switches

Switch
DIPA-1
DIPA-2
DIPA-3
DIPA-4
DIPA-5
DIPA-6
DIPA-7
DIPA-8
q
Presser does not automatically lift after sewing
is completed.
Pedal mode is switched.
User program mode is available.
–
The presser does not rise automatically when a split is found.
Displays the enlargement/reduction ratio in millimeter units instead of as a
percentage. (After changing this setting, be sure to carry out the auto-clear
operation by referring to page 44.)
Enlargement of pattern size is not available.
Program number is fixed.
LK3-B434E Mark II
12. CHANGING FUNCTIONS USING THE DIP SWITCHES
The functions shown in the table below can be
changed by means of these DIP switches q.
* All DIP switches are set to OFF at the time of ship-
ment.
NOTE:
Always turn off the power before setting the DIP
switches.
Motion when set to ON
See "14. Setting the presser
mode"
48