Changing Functions Using The Dip Switches; Operation Panel Dip Switches - Brother KE-484C Instruction Manual

12. CHANGING FUNCTIONS USING THE DIP SWITCHES

12. CHANGING FUNCTIONS USING THE DIP SWITCHES

12-1. Operation panel DIP switches

Switch
DIPA-1
DIPA-2
DIPA-3
DIPA-4
DIPA-5
DIPA-6
DIPA-7
DIPA-8
45
Presser does not automatically lift after sewing is completed.
Pedal mode is switched.
User program mode is available.
−
The presser does not rise automatically when a split is found.
Displays the enlargement/reduction ratio in millimeter units instead of as a percentage. (After
changing this setting, be sure to carry out the auto-clear operation by referring to page 42.)
Enlargement of pattern size is not available.
Program number is fixed.
The functions shown in the table below can be changed by
means of these DIP switches (1).
* All DIP switches are set to OFF at the time of shipment.
Note:
Always turn off the power before setting the DIP switches.
2586Q
Motion when set to ON
KE-484C
See "14. Setting the presser mode"
0176Q